I was attacked by two wild animials during this phase. I barely made it out alive. My Visio drawing wasn't so lucky.
Here's the board laid out for easy drilling (Or so I thought)...
Just an FYI to anyone, apparently paper tears easy (who the hell would've guessed). So, when your drilling out your buttons with your 1 1/8" circle bit, chances are that that you may tear he heck out of adjacent buttons. So, if I hadn't spent so much time taping this this down, I would probably rip it off and bust out the measuring stick.
As you may have noticed, I did not use MDF for the control panel. The rest of my cab (that is not framing) is MDF. I did not want the panel to be too heavy because I thought it would make the weight dispursment a little awkward. Plus I plan to store a few controllers, etc... inside the control panel box (As you will see, once I build it), so it will be opened frequently. I might change my mind later on but we'll see how it goes.
No comments:
Post a Comment